The influence of film structure on the interfacial friction in annular two-phase flow under microgravity and normal gravity conditions

Abstract

Results for the interfacial friction factor and relative interfacial roughness on the gas-liquid interface are reported for an air-water annular flow in a small inner diameter tube (9.53 mm i.d.). The film structure was obtained through processing the time trace signal of film thickness measurements using conductance probes. The interfacial friction factor and the wave height were altered through changing the gravity level and gas Reynolds number. It was found that the wave height decreased with increasing the gas Reynolds number. The wave height in microgravity is less than half of that in normal gravity, while the friction factor was about 10% smaller in microgravity than that in normal gravity. It was shown that the annular two-phase flow friction factor decreased less dramatically as the relative interfacial roughness decreased compared to the single-phase case. It is interesting to note that the interfacial shear stress values at microgravity were very close (or even larger than) those at normal gravity. This was attributed to the thicker substrate at microgravity.