Abstract
The structure, behavior and properties of gypsum mortars with different types of fine aggregates were studied. Investigation by scanning electron microscopy shows that the presence of aggregate particles significantly influences the shape and size of gypsum crystals in the interfacial transition zone. The porosity of the gypsum matrix in mortars is greater than the porosity of pure gypsum paste and the pore size distribution shifts towards smaller pores. The shape and size of crystals in the transition zone depends on the surface roughness of the aggregate particles. The grain surface roughness was measured by confocal laser scanning microscopy. The properties of mortars also depend on the grain surface roughness. The workability, setting times and thermal conductivity decrease with increasing grain surface roughness, while the strength and water vapor resistance increase.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.