The influence of confinement on the penetration of ceramic targets by KE projectiles at 1.8 and 2.6 km/s

Abstract

This paper presents the results of scale size experiments using a tungsten-alloy long-rod projectile fired against 97.5% Al 2O 3 ceramic targets at 1.8 and 2.6 km/s. Two targets were used, one having lateral steel confinement; the other without. The projectile overmatched the target, and residual projectile length and velocity were recorded using ballistic-syncro photography. Flash radiography was used during penetration of the unconfined target to obtain the penetration velocity. Manganin pressure gauges were also used to obtain additional data on the response of the ceramic target during penetration. Results from the eight experiments indicate that the confinement reduced the residual energy of the projectile at both impact velocities. Expressed in terms of the projectile impact energy, 55–56% was lost in the unconfined target at 2.6 km/s compared with 60% for the confined design. The same trend was found at 1.8 km/s with 68% and 72–73% for the unconfined and confined, respectively. Predictions using the QinetiQ GRIM2D hydrocode and a simplified form of the Johnson–Holmquist ceramic material model agreed well with the experiments for three out of the four test configurations. The predicted projectile erosion and retardation against the confined target at 1.8 km/s was excessively high. Analytical predictions using the Tate modified Bernoulli equation also gave reasonably accurate predictions for three of the tests, but values for the Tate target ‘strength’ extracted from experiments using a different target configuration were not accurate for the target design used in this paper.