The influence of cetane-detergent additives into diesel fuel increased to 10% (V/V) of RME content on energy parameters and exhaust gas composition of a diesel engine

Abstract

To avoid the negative effects of increasing the amount of RME in the diesel fuel (to 10%), three different additive packages were used: stabilising, cleaning, and increasing the cetane number with different concentrations. The tests were carried out using a 4-cylinder, turbocharged 1.9 TDI engine from VW. The tests were carried out for 4 fuels (comparative fuel with a content of 7% RME and 3 test fuels with a content of 10% RME, differing in the content of the additive package.It was found that each of the 3 additive packages used does not have a significant impact on fuel consumption. However, a different effect of the tested additives on the composition of exhaust gases was observed. The first package had a slight effect on reducing the NOx concentration in the exhaust, but only for small engine loads. On the other hand, the second additive pack worked more effectively only at higher engine loads (in relation to the reduction of NOx concentration in the exhaust gases). In the third packet, the amount of the cetane additive was doubled (compared to the second packet). Then, the reduction in the NOx concentration in the exhaust gas by 3–8% was obtained with reference to the comparative fuel.