Abstract
The effects of carbon sources and carbon content on the density, microstructure, hardness and elastic properties of dense SiC ceramics were investigated. The precursor powders were prepared by adding 1.5-4.5wt.% C (carbon lamp black or phenolic resin) and 0.5 wt.% B4C to SiC and sintered at 1900?C for 15min under 50MPa pressure in argon with an intermediate dwell at 1400?C for 30min. The results showed that carbon lamp black provided better mixing than phenolic resin since carbon cluster was found in the samples made with phenolic resin. Increasing carbon content causes the decrease of 4H polytype amount in the samples. The presence of higher than 1.5wt.% carbon inhibits grain growth and the presence of the 4H polytype. SiC samples can be produced with relative density of more than 99%TD with 1.5wt.% carbon lamp black addition which shows small average grain size, high elastic modulus and hardness of 2.28 ?m, 453GPa and 21.2GPa, respectively.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have