Abstract
The melt-spun Co- and Fe-based amorphous alloys have been investigated extensively for applications in magnetic devices, which require magnetically soft materials. Although these alloys exhibit excellent soft magnetic properties, their thin sheet shape, which is a consequence of the low glass forming ability, limits significantly their engineering applications. A powder metallurgy is thus an alternative way of producing bulk and, at the same time, soft magnetic materials, having desired shape. In our case, Co56Fe16Zr8B20 and Co70.3Fe4.7Si10B15 amorphous ribbons have been ball-milled for a short time and subsequently compacted (by hot pressing) into disc-shaped specimens with the aim to achieve samll values of resulting coercivity. This work is focused only on the first preparation step i.e. on structural and magnetic properties of ball-milled powders obtained by ball-milling of Co-based melt-spun ribbons at different conditions. Two different ways of milling were employed in order to obtain a powder form of the material: the ribbons were either continuously ball-milled for up to 12 hours or, after each half an hour of ball-milling, the vials were cooled in liquid nitrogen bath for half an hour. Mossbauer spectroscopy, X-ray diffraction and differential scanning calorimetry were employed to compare and to present the differences between these two different ways of milling.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.