The impact of chelating agent pH on the stability and viscosity of CO2 foam under harsh reservoir conditions

Abstract

The injection of CO2 foam into the carbonate reservoir for enhanced oil recovery (EOR) has attracted special interest in the last decades; nevertheless, the understanding of the effect of liquid solution chemistry on foam stability at high temperatures and salinities is limited. Hence, this paper fully investigates the effect of chelating agents L-glutamic acid-N, N-diacetic acid (GLDA) pH, and hydrochloric acid (HCl) on the stability and viscosity of generated CO2 foam for heterogeneous carbonate formation under reservoir conditions. In this paper, Duomeen TTM and Armovis VES surfactants were utilized due to their capabilities to produce viscous CO2 foam under harsh conditions. The foamability, foam stability, and foam structure were studied at 100 °C and 1000 psi using a high-temperature and high-pressure (HPHT) foam analyzer. The measurement of CO2 foam viscosity was determined at 100 °C, 1000 psi, and 70 % foam quality using the HPHT foam rheometer. Rheology experiments and dynamic light scattering investigated the micelle’s size or aggregation behavior of surfactants. The obtained results showed that the Duomeen TTM generated unstable foam; however, foam stability and foamability improved with the decrease in GLDA pH. Armovis VES showed excellent CO2 foam performance, where the foam half-life time of Armovis VES systems was 240 min. The liquid drainage and bubble coarsening were delayed due to the formation of the viscoelastic liquid phase. The foamability of Armovis VES was improved as the GLDA pH decreased. Furthermore, the addition of HCl to Armovis VES solution presented the highest foamability. The outcomes of the HPHT foam analyzer and HPHT viscometer proved that as the pH of Armovis VES solution decreased, higher foamability was produced. The highest foam viscosity was obtained using the synergic effect of 0.5 wt% Duomeen TTM and 0.5 wt% Armovis VES (39 cp at 100/s). In comparison, 1 wt% Armovis VES presented the lowest foam viscosity (30 cp at 100/s). The outcomes of this research can provide insight into the effect of chemistry on CO2 foam and extend its application in oilfield development. This work broadens the design of novel CO2 foam formulation, leading to the improvement of sweep efficiency in CO2-EOR methods and enhance the gas trapping in carbon storage.