Abstract
The aim of this study was to determine the impact of additions of tungsten carbide and silicon carbide microparticles to the lubricant used in the burnishing process on the tribological properties of friction pairs. The cylinders made of AISI 1045 steel constituted a workpiece. Burnishing was made with a lubricant the SN150 base oil with addition of tungsten carbide and silicon carbide microparticles. The tested materials were burnished with forces of 1000 N and 1500 N. Before and after the burnishing process, the surface roughness and hardness of the tested materials were measured. The study also presents the results of tribological properties of friction pairs with the tested structural materials. It was found that the addition of tungsten carbide microparticles to the base oil in the burnishing process can result in improved surface quality and reduced surface roughness. The results also confirmed the effect of addition of tungsten carbide and silicon carbide to the lubricant used in the burnishing process on tribological properties.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: International Journal of Applied Mechanics and Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.