Abstract
Polypropylene sheet composites were produced by both the melt consoli dation and slurry deposition processes. The resulting composites had comparable flexural properties, based on the efficiency of the glass fiber reinforcement, but dissimilar impact strengths. The impact strength of the composites was found to be related to a number of factors, including the degree of adhesion between the polymer and reinforcing glass fibers, the concentration of glass fibers, and the length of the fibers. The impact properties of the melt impregnated composites were quite high. Melt impregnated polypropylene compos ites absorbed up to 257 J/cm during an instrumented falling dart impact test. The impact properties of the slurry formed composites were much less, only 62 J/cm.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.