Abstract

The model for intrinsic defects in Cu(In,Ga)Se2 semiconductor layers is still under debate for the full range between CuInSe2 and CuGaSe2. It is commonly agreed by theory and experiment, that there are at least one shallow donor and two shallow acceptors. Spatially resolved photoluminescence on CuGaSe2 previously revealed a third acceptor. In this study we show with the same method that the photoluminescence peak at 0.94 eV in CuInSe2, previously attributed to a third acceptor, is a phonon replica. However another pronounced peak at 0.9 eV is detected on polycrystalline CuInSe2 samples grown with high copper and selenium excess. Intensity and temperature dependent photoluminescence measurements reveal that this peak originates from a DA-transition from a shallow donor (<8 meV) into a shallow acceptor A3 (135 10) meV. The DA3 transition has three distinct phonon replicas with 28 meV spectral spacing and a Huang Rhys factor of 0.75. Complementary admittance measurements are dominated by one main step with an activation energy of 125 meV which corresponds well with the found A3 defect. The same defect is also observed in Cu(In,Ga)Se2 samples with low gallium content. For [Ga]/([Ga] + [In])-ratios of up to 0.15 both methods show a concordant increase of the activation energy with increasing gallium content shifting the defect deeper into the bandgap. The indium vacancy is discussed as a possible origin of the third acceptor level in CuInSe2 and in Cu(In,Ga)Se2.

Highlights

  • Solar cells made from chalcopyrite absorber layers Cu(In,Ga)Se2 (CIGS) achieve the highest power conversion efficiencies of all thin film solar cells, reaching up to 23.3 % [1, 2]

  • Transition seen in low temper­ature PL measurements of CuGaSe2 was first attributed to be a phonon replica [6], but later shown by spatially resolved PL [12] and CL [7] measurements, to be a third independent donor-acceptor pair transition (DA)

  • The Cu(In,Ga)Se2 samples are grown in a modified three-stage-process [15, 16], in which the duration of the third stage defines the overall [Cu]/([Ga] + [In])-ratio (CGI)

Read more

Summary

Introduction

Solar cells made from chalcopyrite absorber layers Cu(In,Ga)Se2 (CIGS) achieve the highest power conversion efficiencies of all thin film solar cells, reaching up to 23.3 % [1, 2].

On leave from
Methods
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call