Abstract


 
 
 The objective of the study was the composition of ash and slag waste from the Zmiiv TPP (thermal power plant) and the peculiarities of migration of heavy metals (HM) from the place of storage of ash and slag waste into the ecosystem. To achieve this goal, the following tasks were solved: chemical analysis of ash and slag waste of the Zmiiv TPP; identification of the probability of HM migration into the soil environment in the places of ash and slag waste storage. Ash and slag of the Zmiiv TPP contain Cu, Cr, As, Cd, Ni, Pb in quantities several times higher than the threshold limit value (TLV). For ash and slag wastes, the total pollution rate was Zc = 43, which corresponds to a high level. That is, this artificial horizon is dangerous. HMs migrate to groundwater and soils near the ash stockpiles as a result of infiltration of precipitation waters, leaks from water-bearing communications, water filtration through the base of the ash stockpiles of the Zmiiv TPP. To determine soil contamination near the ash stockpiles, we analyzed soil at the distances of 0, 5, 10, 50 and 100 meters. The contents of the HM decreased further away from the stockpiles. At the distance of up to 100 meters from the dump, there were excesses of the threshold limit values for Ni, Cu, As, Cr in the soil. The concentration factor exceeded one for Cr, As, Cu, Cd, Ni. Only at the distance of 100 meters did the contents of Pb and Zn reached the background values. The calculation of the total rate of soil contamination allowed us to classify these soils as moderately dangerous and acceptable. However, the Zn indicator has several significant disadvantages, particularly it does not take into account the differences in the potential hazards of the elements, as well as, most importantly, the synergistic effects of polymetallic pollution. The coefficient of synergistic effect of heavy metals was 26.64 (in the soil of the ash stockpiles), then decreased, but even at the distance of 100 meters it equaled 11.23, i.e. at the distance of 0... 100 m from the ash stockpiles, the overall actions exceed the norm. The study revealed that Cu, Ni, Zn and Cr had low mobility in the soil near the ash stockpiles and therefore accumulated near the stockpiles, which may be explained by neutral and slightly alkaline soil pH values. The ratio of mineral phases and glass varied, but we should note the predominance of aluminosilicates, calcium silicates and glass in the ash and slag wastes. Heavy metal compounds are confined mainly to amorphized clay aggregates and soot-coal ash formation, to a lesser extent to slag glass and even less to grains of quartz sand. Since ash contains such fractions that can be easily carried by the wind, it should be assumed that ingress of HM into the ecosystem occurs by air, which also contributes to air pollution. The solution to the problem of ash and slag waste disposal can be found in their utilization in the production of construction materials, in road construction, but it is necessary to study the composition of ash and slag and the probability of migration of HM depending on the conditions of use.
 
 

Highlights

  • IntroductionThe work of TPPs (thermal power plants) generates wastes: ash and slag (heavy fraction) and ash (volatile fracture)

  • The work of TPPs generates wastes: ash and slag and ash

  • Despite the fact that the samples contained Cu, Cr, As, Cd, Ni, Pb in concentrations that were several times higher than the threshold limit value (TLV) (Table 1), the chemical analysis of the samples of ash and ash and slag wastes of the TPP indicated that these values may be dozens of times higher

Read more

Summary

Introduction

The work of TPPs (thermal power plants) generates wastes: ash and slag (heavy fraction) and ash (volatile fracture). A number of researchers report the great threat these wastes pose and the possibility of using ash and slag in production of construction materials, road construction, which would reduce the expenditures of raw material, and even propose using them as fertilizers For example, generation of electric energy in Ukraine in 2019 accounted for 141.2 B kW, over a third of this energy was generated by TPPs and CHP (combined heat and power) stations (Statistichnij shhorіchnik Ukrainу, 2019). During the generation of thermal energy, thermal power was 129,045 GCal/year, and the main providers of the thermal energy were thermo-regulating units, heating plants, TPPs and CHPs, the work of which left ash and ash-and-slag waste. The Zmiiv TPP is among the five largest TPPs, with power over 2,000 MW (Fig. 1, 2)

Objective of the study
Materials and methods
Results and their analysis
Background content
Conclusions
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call