Abstract
The aim of this article is to explore the dynamic compaction characteristics of stone mastic asphalt (SMA) and the friction-lubrication effect of internal particles during the superpave gyratory compaction (SGC) process. Firstly, a calculated method for the compaction degree of an asphalt mixture in the gyratory compaction process was defined based on the multiphase granular volume method. Secondly, the gyratory compaction curves of asphalt mixtures were taken based on this calculation method of compaction degree. The dynamic change law of each compaction index (compaction, percentage of air voids, compaction energy index, etc.) during the compaction process was analysed. Finally, the effects of different initial compaction temperatures and different asphalt content on the friction-lubrication effect and compaction characteristics of asphalt mixtures were studied. Research shows that it is reasonable to define the compaction degree by the ratio of the apparent density of the asphalt mixture to the maximum theoretical density of the asphalt mixture during gyratory compaction. The dynamic prediction equations of the compaction degree K and the compaction energy index CEI with the amount of compaction were established, and could effectively predict the compaction degree, percentage of air voids and compaction energy index CEI. The compaction process of the asphalt mixture needed to go through three phases, including periods of rapid growth, slow growth, and stabilisation, and the compaction degree increased by about 10%, 5%, and 1%, in that order, finally tending towards a stable value. The effect of the initial compaction temperature on the forming compaction degree of the asphalt mixture is significant; therefore, it should be controlled strictly in the compaction construction of asphalt mixtures. When the initial compaction temperature of SMA-13 is about 170 °C, the compaction effect is optimal, and the effect of the increase in the amount of compaction at a later stage on the increase in the compaction degree of the asphalt mixture is very low. With the optimal asphalt content, the friction-lubrication effect between the asphalt and aggregate particles is optimal, because it can effectively form an asphalt film, reducing the frictional resistance of the particles moving each other during the compaction process, and the voids will be embedded and filled with each other, finally producing the best compaction result.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.