The fracture of wood under torsional loading

Abstract

A series of experiments have been carried out on hardwood (red lauan) and softwood (sitka spruce) test pieces using static and cyclic torsional loading under displacement control. Measurements of the applied torque, the corresponding angle of twist and the number of cycles to failure were recorded. It was found that under static torsional loading, the strength of both hardwood and softwood reduced as the grain orientation of the sample to the axis of twist increased from 0° to 90° with a corresponding decrease of elastic modulus. Hardwood is stronger than softwood. In the fatigue test, when the torsional load is plotted against cycle number, the results showed that under displacement control stress relaxation occurs. The S–N curve for softwood has a shallower gradient than that of hardwood, indicating that the torsional strength of softwood is less affected by fatigue loading than hardwood. In both static and cyclic torsional loading tests, the failure mode of hardwood is slow and incomplete, whereas, softwood fails suddenly and completely. The crack growth is along the tangential direction in the hardwood cross-section and in the radial direction in the cross-section.