Abstract
The formation of a water-in-oil ( W O ) microemulsion with a water phase containing up to 30% w/w NaNO 2 and diesel oil as the oil phase, with the cationic surfactant cetyltrimethylammonium bromide (CTAB) and an alcoholic cosurfactant has been examined. The cosurfactant chain length, alcohol isomerism, solution salinity, temperature, CTAB:alcohol ratio and the effect of combining various alcohols were studied. The best set of conditions for the formation of a microemulsion with a maximum salt concentration whilst utilising a minimal amount of surfactant have been determined. The use of short chain unbranched alcohols (C3–C5), especially 1-butanol, or a combination of short alcohols (1-butanol and 2-propanol), and a CTAB:alcohol ratio between 60:40 and 70:30, with 68:32 are seen to be of primary importance for microemulsion formation. In addition, the extent of the W O region on the phase diagram is shown to be temperature dependent, with higher temperatures increasing the extent of the one phase region.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Colloids and Surfaces A: Physicochemical and Engineering Aspects
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
