Abstract
The automotive power steering units must be taken performance test after they are integrated assembly and then left the factory if it is qualified.Because its internal flow channel is very complicated and the residual hydraulic oil can not be eleminated clearly.So we can set up a 3D model flow channel based on CATIA and use FLUENT software to analysis the key flow channel ,analysing it's pressure distribution and velocity vector diagram then get the real reasonable resluts ,which can provide the basic for the ejector designing
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
