The fidelity of melt inclusions as records of melt composition

Abstract

A series of experiments created melt inclusions in plagioclase and pyroxene crystals grown from a basaltic melt at 1,150°C, 1.0 GPa to investigate diffusive fractionation during melt inclusion formation; additionally, P diffusion in a basaltic melt was measured at 1.0 GPa. Melt inclusions and melts within a few 100 microns of plagioclase–melt interfaces were analyzed for comparison with melt compositions far from the crystals. Melt inclusions and melt compositions in the boundary layer close to the crystal–melt interface were similar, but both differ significantly in incompatible element concentrations from melt found greater than approximately 200 microns away from the crystals. The compositional profiles of S, Cl, P, Fe, and Al in the boundary layers were successfully reproduced by a two-step model of rapid crystal growth followed by diffusive relaxation toward equilibrium after termination of crystal growth. Applying this model to investigate possible incompatible element enrichment in natural melt inclusions demonstrated that at growth rates high enough to create the conditions for melt inclusion formation, ∼10−9–10−8 m s−1, the concentration of water in the boundary layer near the crystal was similar to that of the bulk melt because of its high diffusion coefficient, but sulfur, with a diffusivity similar to major elements and CO2, was somewhat enriched in the boundary layer melt, and phosphorus, with its low diffusion coefficient similar to other high-field strength elements and rare earth elements, was significantly enriched. Thus, the concentrations of sulfur and phosphorus in melt inclusions may over-estimate their values in the bulk melt, and other elements with similar diffusion coefficients may also be enriched in melt inclusions relative to the bulk melt.