Abstract
The fatigue strength of two-pin dowel end to side-grain rubberwood furniture joints made from PVAc of different glueline thickness and joint assembly times were compared. Joints assembled immediately after machining had significantly higher strength compared to those joints assembled after 1 week and 1 month. The results showed that the allowable design stress for PVAc dowel adhesive joints of 0.01 mm glueline thickness could be set at 25 % of its ultimate bending moment, which conforms to the strength requirements in service.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
