Abstract

Approximately 85% of Australia's population live along the coastal fringe, an area with high exposure to extreme inundations such as tsunamis. However, to date, no Probabilistic Tsunami Hazard Assessments (PTHA) that include inundation have been published for Australia. This limits the development of appropriate risk reduction measures by decision and policy makers. We describe our PTHA undertaken for the Sydney metropolitan area. Using the NOAA NCTR model MOST (Method for Splitting Tsunamis), we simulate 36 earthquake-generated tsunamis with annual probabilities of 1:100, 1:1,000 and 1:10,000, occurring under present and future predicted sea level conditions. For each tsunami scenario we generate a high-resolution inundation map of the maximum water level and flow velocity, and we calculate the exposure of buildings and critical infrastructure. Results indicate that exposure to earthquake-generated tsunamis is relatively low for present events, but increases significantly with higher sea level conditions. The probabilistic approach allowed us to undertake a comparison with an existing storm surge hazard assessment. Interestingly, the exposure to all the simulated tsunamis is significantly lower than that for the 1:100 storm surge scenarios, under the same initial sea level conditions. The results have significant implications for multi-risk and emergency management in Sydney.

Highlights

  • The exposure of Sydney (Australia) to earthquake-generated tsunamis, storms and sea level rise: a probabilistic multi-hazard approach

  • To date, no Probabilistic Tsunami Hazard Assessments (PTHA) that include inundation have been published for Australia

  • Australia is at risk from tsunamis but due to its geographic proximity to different seismic source regions, the tsunami hazard around Australia varies significantly[1] (Figure 1a)

Read more

Summary

Introduction

The exposure of Sydney (Australia) to earthquake-generated tsunamis, storms and sea level rise: a probabilistic multi-hazard approach. To date, no Probabilistic Tsunami Hazard Assessments (PTHA) that include inundation have been published for Australia. The vertical component of the crustal deformation of each earthquake was used as the initial condition of a finite-difference numerical model to propagate each tsunami towards the coast reaching a bathymetric contour of -100m. This produced a maximum tsunami wave amplitude (at the -100m contour) for each earthquake, associated to its probability of occurrence. To the best of our knowledge, no PTHAs that incorporate onshore inundation modelling have been published in Australia

Objectives
Methods
Results
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.