The evolution of pelvic canal shape and rotational birth in humans

Ekaterina Stansfield,Maria Villa Pouca,Barbara Fischer,Nicole D S Grunstra,Nicole D S Grunstra,Nicole D S Grunstra,Maria Villa Pouca,Philipp Mitteroecker

doi:10.1186/s12915-021-01150-w

Abstract

BackgroundThe human foetus typically needs to rotate when passing through the tight birth canal because of the complex shape of the pelvis. In most women, the upper part, or inlet, of the birth canal has a round or mediolaterally oval shape, which is considered ideal for parturition, but it is unknown why the lower part of the birth canal has a pronounced anteroposteriorly oval shape.ResultsHere, we show that the shape of the lower birth canal affects the ability of the pelvic floor to resist the pressure exerted by the abdominal organs and the foetus. Based on a series of finite element analyses, we found that the highest deformation, stress, and strain occur in pelvic floors with a circular or mediolaterally oval shape, whereas an anteroposterior elongation increases pelvic floor stability.ConclusionsThis suggests that the anteroposterior oval outlet shape is an evolutionary adaptation for pelvic floor support. For the pelvic inlet, by contrast, it has long been assumed that the mediolateral dimension is constrained by the efficiency of upright locomotion. But we argue that the mediolateral elongation has evolved because of the limits on the anteroposterior diameter imposed by upright posture. We show that an anteroposteriorly deeper inlet would require greater pelvic tilt and lumbar lordosis, which compromises spine health and the stability of upright posture. These different requirements of the pelvic inlet and outlet likely have led to the complex shape of the pelvic canal and to the evolution of rotational birth characteristic of humans.

Highlights

The human foetus typically needs to rotate when passing through the tight birth canal because of the complex shape of the pelvis
We show that this complex shape has emerged as an evolutionary compromise to different, partly antagonistic selective forces acting on the pelvis: The shape of the birth canal is subject to selection for childbirth, pelvic floor support and upright posture
The anteroposterior oval shape of the lower pelvic canal is an evolutionary adaptation for pelvic floor support

Summary

Introduction

The human foetus typically needs to rotate when passing through the tight birth canal because of the complex shape of the pelvis. Human childbirth typically involves a complex rotational motion of the foetal head, followed by the shoulders and rest of the body, as the baby passes through the birth canal (Fig. 1A). The size of the pelvic floor, as determined by the dimensions of the bony pelvis, affects the risk of developing pelvic floor disorders. Clinical and biomechanical studies [25,26,27,28,29] confirmed that a larger birth canal increases the risk of pelvic floor disorders, because a larger pelvic floor must be able to bear higher stresses and strains and shows larger vertical displacement under pressure

Methods

Results

Discussion

Conclusion