The erosion behaviors of Y 2O 3 and YF 3 coatings under fluorocarbon plasma

Abstract

We deposited Y 2O 3 and YF 3 coatings using the electron beam evaporation method and investigated their erosion behavior under fluorocarbon plasma at various bias voltages. TEM analysis revealed that the Y 2O 3 coating was strongly fluorinated under the plasma, and the thickness of the fluorinated layer was increased up to a few hundred nm with bias voltage. XPS analysis also confirmed a significant Y–F bonding on the surface and showed fluorine content at a maximum on the surface, decreasing with the depth from the surface. The etch rate increased with bias voltage and it was slightly higher in YF 3 coating, implying that the etch rate depends on the surface fluorination and its removal by incident ions. Without applying bias voltage, the chemical reaction with the fluorocarbon plasma dominated, resulting in the formation of fine fluoride particles on the Y 2O 3 surface, but the YF 3 coating was intact and clean for the same condition. These results indicate that the YF 3 coating may be a new plasma-facing material that produces fewer contamination particles.