Abstract
Electrostatic-alloy bonding of silicon wafer with glass deposited by Au to form Si/Au-glass water, and bonding of Si/Au-glass with silicon wafer were researched during fabrication of pressure sensors. The silicon wafer and glass wafer with an Au film resistor were bonded by electrostatic bonding, and then Si-Au alloy bonding was formed by annealing at 400°C for 2 h. The air sealability of the cavity after bonding was finally tested using the N2 filling method. The results indicate that large bond strength was obtained at the bonding interface. This process was used in fabricating a pressure sensor with a sandwich structure. The results indicate that the sensor presented better performances and that the bonding techniques can be used in MEMS packaging.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
