The effects of wood fiber directions on bonding performance

Abstract

Using engineered wood products (EWPs) in the building technologies is very crucial in terms of sustainable approaches. They provide; low weight, high structural stiffness, carbon storage capacity and easy erection on site. EWPs are composite materials that are influenced by a variety of factors that play a critical role in their formation. The chemical ingredients of the wood, the curing process of the adhesive, the type of wood, the relationship between the adhesive and the wood species, the curing temperature, the geometric configuration of the lamellae, etc. can all be included under the heading of these factors. In contrary with massive wood, to obtain EWPs different types of adhesives can be used. Therefore adhesive type and its application method affects the quality of wooden structural element. Choosing the appropriate adhesive is one of the steps to be taken to obtain the structurally correct product. Based on this approach, it was decided to investigate the adhesion performance of different adhesive types. This paper aims to present the best bonding method among the melamine urea formaldehyde (MUF) and epoxy adhesives by considering the fiber directions of the wood and the type of adhesive according to the load. One of the aims of this study is to investigate the effect of changing the fiber direction of wood on adhesion performance, taking into account the current gap in the literature. Pull-off tests were conducted to assess the bonding performance of different types of adhesive in wood samples with varying fiber direction. The wood samples were bonded to the wood surface with varying grain directions. During the pull-off tests, ruptures in the glue line of the test samples were commonly observed. The results have shown that in cylindrical samples bonded with epoxy, the highest bonding strength values were observed in scenarios where the wood fibers were oriented parallel to the load direction and perpendicular to the ground plane. Similarly, for wood samples used as the bonding surface, the highest bonding strength values were achieved when the wood fibers were oriented parallel to the load direction and perpendicular to the surface plane. On the other hand, the highest value in pull-off test setups was found with melamine urea formaldehyde adhesive; commonly used in laminated timber, between the wood samples with grains perpendicular to the load direction and the wood adherence surfaces with a parallel grain direction. In summary, the highest strength value was obtained from the test setup in which epoxy was used as the adhesive and both the wood specimens and the wood bonding surface had fiber directions parallel to the load direction.