The effects of TiO 2 nanoparticles on physical, thermal and mechanical properties of concrete using ground granulated blast furnace slag as binder

Abstract

In the present study, flexural strength, pore structure, thermal behavior and microstructure characteristics of concrete containing ground granulated blast furnace slag and TiO 2 nanoparticles as binder have been investigated. Portland cement was replaced by different amounts of ground granulated blast furnace slag and the properties of concrete specimens were investigated. Although it negatively impacts the properties of concrete at early ages, ground granulated blast furnace slag was found to improve the physical and mechanical properties of concrete up to 45 wt% at later ages. TiO 2 nanoparticles with the average particle size of 15 nm were partially added to concrete with the optimum content of ground granulated blast furnace slag and physical and mechanical properties of the specimens were measured. TiO 2 nanoparticle as a partial replacement of cement up to 3 wt% could accelerate C–S–H gel formation as a result of increased crystalline Ca(OH) 2 amount at the early age of hydration and hence increase flexural strength of concrete. The increased the TiO 2 nanoparticles’ content more than 3 wt%, causes the reduced the flexural strength because of the decreased crystalline Ca(OH) 2 content required for C–S–H gel formation and unsuitable dispersed nanoparticles in the concrete matrix. TiO 2 nanoparticles could improve the pore structure of concrete and shift the distributed pores to harmless and few-harm pores.