Abstract
In this study, we report the effects of the substrate rotational speed on the morphological characteristics of lithium fluoride (LiF) during thermal evaporation. LiF is used as a typical material in a vacuum-level shift-based electron injection layer and can improve both the charge injection and light emission properties when inserted into the electrode/organic material interface of organic light-emitting diodes (OLEDs). In general OLED research, rotary evaporation is widely used to ensure uniformity. However, there are few reports regarding the effects of this rotary evaporation method on the morphological characteristics of the thin films. Therefore, in this study, we analyzed the effects of rotary variations on the morphological and electron injection characteristics during deposition. The root mean square roughness of the LiF thin film deposited on Alq₃ changed by up to 12.3%. Additionally, the driving voltage of the electron-only device showed a difference of 2.3 V at maximum and a change in the slope of the ohmic region was demonstrated. The morphological change in the LiF thin film based on the rotational speed of the substrate had a significant influence on the reaction at the electrode/organic material interface.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
