Abstract
The hard metallic particle as reinforcements can improve the strength of Al matrix without severely sacrificing its ductility. However, it is technically challenging to fabricate metallic particle reinforced aluminum matrix composites (AMCs) for easy reactivity of Al with most metals. In the present work, friction stir processing (FSP) was used to disperse titanium particles into 5083 Al matrix to fabricate AMCs. Especially, FSP was performed in water to better inhibit the Al/Ti interfacial reaction and the recrystallized grain growth. The effects of the external water on the microstructure and mechanical properties of FSPed AMCs were investigated. Results showed that the external water significantly lowered peak temperature and increased cooling rate, which not only rapidly reduced material flow, but also effectively inhibited grain growth, thereby creating finer grains about 1μm. Also, an excellent Al/Ti interfacial bonding consisting of an element solid solution was obtained in both FSPed composites. Tensile test results indicated that water-FSPed AMCs possessed the higher yield strength (265MPa) and ultimate tensile strength (423MPa) compared with the 5083Al matrix (YS: 198MPa, UTS: 301MPa) and the air-FSPed AMCs (YS: 236MPa, UTS: 383MPa). Moreover, an appreciable amount of ductility (14.9%) was retained despite of their evidently increased strength.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have