The effect of water temperature on air entrainment, bubble plumes, and surface foam in a laboratory breaking-wave analog

Abstract

Air-entraining breaking waves form oceanic whitecaps and play a key role in climate regulation through air-sea bubble-mediated gas transfer, and sea spray aerosol production. The effect of varying sea surface temperature on air entrainment, subsurface bubble plume dynamics, and surface foam evolution intrinsic to oceanic whitecaps has not been well studied. By using a breaking wave analog in the laboratory over a range of water temperatures (Tw = 5°C to Tw = 30°C) and different source waters, we have examined changes in air entrainment, subsurface bubble plumes, and surface foam evolution over the course of a breaking event. For filtered seawater, air entrainment was estimated to increase by 6% between Tw = 6°C and Tw = 30°C, driven by increases of about 43% in the measured surface roughness of the plunging water sheet. After active air entrainment, the rate of loss of air through bubble degassing was more rapid at colder water temperatures within the first 0.5 s of plume evolution. Thereafter, the trend reversed and bubbles degassed more quickly in warmer water. The largest observed temperature-dependent differences in subsurface bubble distributions occurred at radii greater than about 700 μm. Temperature-dependent trends observed in the subsurface bubble plume were mirrored in the temporal evolution of the surface whitecap foam area demonstrating the intrinsic link between surface whitecap foam and the subsurface bubble plume. Differences in foam and plume characteristics due to different water sources were greater than the temperature dependencies for the filtered seawater examined.