The effect of three types of rasps on the occlusal surface of equine cheek teeth: a scanning electron microscopic study.

Abstract

Two hand rasps (tungsten chip blade, solid carbide blade) and an electrically-driven solid carbide axial bur were used to treat the cheek teeth of 2 horses immediately postmortem. All teeth were normal and were rasped to a standard considered satisfactory in practice. Six teeth from each horse served as untreated controls. Following treatment, the teeth were extracted and the clinical crown removed and prepared for scanning electron microscopy. Teeth were also extracted and examined from a horse that had excessive dental treatment previously. Dental debris created by the procedures was collected and examined. All three rasp techniques resulted in amputation of odontoblast processes. The solid carbide blade cut deep gouges and grooves into the surface of the dentin, chipping the enamel and peripheral cement. No smear layer was created. Rasping with a tungsten chip blade created a partial smear layer and a smoother surface than the solid carbide blade. The electrically-driven bur produced a complete smear layer and removed all dental tissues to a smooth layer. The enamel had also been damaged by the electric bur. Crown particles collected after the procedures were larger following hand rasping compared with particles produced by the electric bur. The extent of damage to sensitive and vital dentin tissue was of concern. Further studies are required to establish the optimum technique for rasping equine cheek teeth.