The effect of the pore structure and zeta potential of porous polymer monoliths on separation performance in ion‐exchange mode

Abstract

Most often, in bioseparations involving charged macromolecules, the chromatographic systems have low Reynolds and high Peclet numbers. For such systems, an expression is developed and presented in this work for evaluating the throughput in polymeric monoliths where ion-exchange adsorption occurs, as a function of (i) the pressure drop along the length of the monolith, (ii) the functional form and width of the throughpore-size distribution of the monolith, and (iii) the magnitude of the zeta potential on the surface of the throughpores of the monolith. Gaussian and log-normal throughpore-size distributions whose mean throughpore-size and standard deviation values are based on experimentally measured throughpore-size distribution data by mercury porosimetry employed on polymeric monoliths are used in this work, and their effect on the throughput relative to that obtained from a polymeric monolith having a uniform throughpore-size distribution is studied for different values of the ratio of the standard deviation to the mean throughpore-size. The results indicate that relatively modest increases in the throughput, when compared with the throughput that could be achieved in a polymeric monolith having a uniform throughpore-size distribution, could be obtained in polymeric monoliths having disperse throughpore-size distributions, and the magnitude of the increase becomes larger when the disperse distribution is skewed to larger throughpore sizes. Furthermore, the results of this work indicate that, under certain conditions, relatively modest increases in the throughput of a charged analyte could also be achieved by altering the value of the zeta potential on the surface of the throughpores of the monolith. Due to the difficulties inherent in controlling the functional form and width of the throughpore-size distribution during the synthesis of polymeric monoliths, it would appear to be more practical to increase the value of the throughput of a charged analyte by altering the value of the zeta potential through prudent selection of the ion-exchange surface functional groups and fine-tuned with the pH of the mobile phase. Thus, for ion-exchange chromatography systems, the zeta potential could be considered an important parameter for column designers and operators to manipulate, since its alteration could increase the through-put of a charged analyte in polymeric monoliths or in columns packed with charged particles.