The effect of the calibre and length of needle on the stability of sclerosing foam.

Abstract

Little is known how calibre and length of needles affect the stability of sclerosing foam. Foams were made of 0.5%, 1%, 2% and 3% polidocanol, and 0.2%, 0.5%, 1% and 3% sodium tetradecyl sulfate (STS), which were mixed with air in the proportion of 4:1. These foams were ejected through needles with the length of: 4 mm, 6 mm and 13 mm, and diameter of: 0.26 mm, 0.3 mm and 0.4 mm. Foams made of more concentrated polidocanol were more stable. Regarding STS an opposite relationship was revealed. Foams made of polidocanol were more stable if ejected through a longer needle, while the length of needle did not significantly affect stability of STS foams. Foams ejected through 0.26 mm diameter needles were very unstable. In the case of 0.5% polidocanol, 0.3x6mm needle provided atypically stable foam. In order to inject maximally stable foam, calibre and length of needle should be taken into account.