The effect of temperature variation on Aluminum Matrix Composite (AMC) Sintering with CNT

Abstract

Material selection is a very important part of the design due to the variety of functions and extreme applications. There is always a need for materials that are light, strong, hard, with good thermal conductivity. Aluminum matrix composites (AMC) are potential candidates for applications that require proper material selection. The most popular AMC processing technique is the powder metallurgy/PM method to produce products with precise dimensions. Powder metallurgy for the mass production of components is the most promising and versatile method. carbon Nanotube (CNT) particle reinforced AMC fabrication is an advanced material for the automobile, aircraft, aerospace, defense, petroleum, chemical industries at a relatively low price with high performance. Al powder 4.98 gr, CNT 0.02 gr with a mixing time of 8 hours at 650 rpm. The specimens were made using a cold uniaxial pressing process at room temperature 27°C. Aluminium – CNT powder is compacted in a rigid molding with a compaction pressure of 160 MPa. Variation of sintering 100°C, 200°C, 300°C, 400°C, 500°C with a time of 60 minutes. The PM method proves that the mechanical properties and physical properties of the material are improved. Material shrinkage after sintering is large by forming shrinkage. Hardness test results with Rockwell, 26.5HR, 27.9HR, 28.8HR 29.9HR, 32.5HR. Wear rate 0.196 mm3/m, 0.078mm3/m, 0.054mm3/m, 0.052mm3/m 0.049mm3/m. Porosity values are 6.30%, 6.28%, 5.98%, 4.51%, 4.58%. The higher the sintering tem-perature, the higher the hardness value, the lower the porosity and wear.