Abstract
This paper reports on an experimental study of the effect of tailwater depth on local scour downstream of stepped-chutes. Different tailwater conditions were tested to study the form of the scour for two gradations of non-cohesive bed material, various flow rates, chute angles, sill heights and step heights. Measurements were taken to obtain the scour hole profile in the equilibrium state of scour, the value of the maximum depth of scour, the location of the maximum scour depth, and the length of the scour hole. The present results indicate that maximum depth and area of scour are highly dependent on tailwater depth. Moreover, the maximum scour depth increases with increases in the discharge and the tailwater depth. It was also found that step geometry, stepped chute angle and the sill types of the stilling basin are very important parameters for scour hole and geometry. A comparison was made between the scour characteristics produced by different tailwater depths. Empirical correlations predicting maximum scour depth were developed. Hence, accurate equations for the maximum scour depth are introduced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
