Abstract
This study evaluated tensile bond strength of a denture soft lining material to a poly (methylmethacrylate) (PMMA) denture base resin subjected to different surface treatment modalities and thermocycling. The materials tested were a silicone-based liner, Molloplast B®, and a heat-cured denture base resin, MeliodentTM. The denture soft lining material was packed against cured PMMA base resin, which was smoothed; sandblasted with 250-μm Al2O3 particles; or lased with a KTP laser; or against uncured PMMA dough (n = 10). In each group, five specimens were thermocycled in a water bath (5–55°C; 3000 cycles) before testing, whereas the other five were directly tested after 24 h. A tensile test was performed using a universal testing machine. Data showed that different treatment modalities of resin surfaces affected adhesion between these two materials and the highest bond values were recorded for cured/smoothed samples under each condition tested. Thermocycling of specimens had no significant reducing effect on measured bond strength values.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
