The Effect of Pre-oxidation Treatment on Corrosion Behavior of Ni–Cu–Fe–Al Anode in Molten CaCl2 Salt

Abstract

This article presents Ni–Cu–Fe–Al alloy as a novel inert anode used in FFC process (the Fray Farthing Chen) in molten calcium chloride salts for producing titanium. The alloy was prepared by vacuum induction melting; then utilized as anode material in molten CaCl2 for 16 h at 900 °C. Morphology and the corrosion behavior of the samples were analyzed using scanning electron microscopy (SEM), and energy dispersive spectroscopy (EDS). The product on the cathode was analyzed using X-ray diffraction (XRD). After 16 h electrolysis of anodes, EDS and SEM analysis of the samples showed that the corrosion depth of the non-oxidized sample was shorter. Corrosion attacks more severe for the pre-oxidized sample than the non-oxidized sample, which indicated that the corrosion resistance of outer layer is higher on the non-oxidized sample. The XRD results show that the TiO2 pellets were successfully reduced to the lower oxides using the Ni–Cu–Fe–Al inert anode.