The effect of potential investment expansion and hot strength on the fit of full crown castings made with phosphate‐bonded investment

Abstract

summary In an earlier investigation, it was shown that when full crowns are cast in gypsum‐bonded investments, their relative inaccuracy is affected by both the investment's potential expansion and its hot strength. This study repeated the earlier one, but used a high‐melting gold alloy and two phosphate‐bonded investments. The investments were used under conditions which gave a range of potential expansions and hot strengths. Casting inaccuracies were determined both diametrally and axially. All castings showed distortion, which varied under the different conditions. All were oversized axially, by amounts varying from +0·8% to +2·3%. Diametral inaccuraciesranged from −0·2%to+0·7%. Investment expansion had a strong effect on axial inaccuracy, but a negligible effect on diametral inaccuracy. Conversely, hot strength had a strong effect on diametral inaccuracy, but only a very weak effect on axial inaccuracy. With phosphate‐bonded investments, both potential expansion and hot strength are important parameters of relative casting inaccuracy. In combination, these properties showed very strong correlations with both diametral and axial inaccuracies. The observed distortions were the result of anisotropic mould expansion and anisotropic alloy shrinkage. The best fit, and least distortion, occurred with an investment setting under dry conditions.