The Effect of Photoanode Interface and Surface Treatment in Dye-Sensitized Photo-Electrochemical Systems for Effective Lignin Decomposition

Abstract

Traditionally, Dye-sensitized photo electrochemical cells (DSPECs) have been targeted for solar-driven water splitting as production of fuels in aqueous media. Recently, hydrogen atom transfer incorporated dye-sensitized photo electrochemical cell (HAT-DSPEC) which used photocatalyst and homogeneous catalysts incorporating system was suggested for the decomposition process of lignin. This HAT-DSPEC system representing conversion efficiencies over 90% resulted in the formation of the oxidized ketone product from model compounds under simulated solar illumination with an applied bias 0.4 V vs Ag/Ag+ for 24 hrs. However, they have several issues such as long reaction time, low stability, and high bias potential.To overcome these problems, in this study, dye-sensitized photovoltaics’ advanced technic is applied. In HAT-DSPEC system, photo-anode (TiO2@Dye) has important role to produce oxoammonium species by oxidizing nitroxyl derivatives, such as 4-acetomido TEMPO (ACT). And these oxoammonium species act as a catalytic reaction with lignin model compounds (LMCs) to oxidizing of 1o or 2o alcohol and cleavage Caryl-Cα bond cleavage. However, in photo-anode, lots of charge recombination and electron back transfer occurs on the FTO and TiO2 surface and it induce low current and reactivity. For effectively producing oxoammonium species from photoelectrode, using blocking layer to passivate FTO surface from electrolytes and applying TiCl4 post-treatment for fast charge transport in TiO2 by enhancing interconnection of TiO2 nanoparticles. The photocurrent response of the m-TiO2@Ru470 photoelectrode in a nonaqueous electrolyte was examined with increasing mediator concentration during light on/off cycles under AM 1.5G illumination (100 mW/cm2), with an applied bias 0.1 V vs Ag/Ag+. Three kinds of electrode condition such as m-TiO2, BL/m-TiO2, BL/m-TiO2/TiCl4 post treatment was examined under same condition and treated photoelectrode (BL/m-TiO2/TiCl4) showed a significant increase in maximum photocurrent up to approximately 367.69 μA/cm2 with 3 mM ACT mediator, while BL/m-TiO2 exhibits 26.75 μA/cm2 and m-TiO2 1.26 μA/cm2. This result indicates that the blocking layer and TiCl4 post treatment enhanced electron lifetime and collection efficiency in the photoelectrode, as well as enhancing the capability of producing oxoammonium species.