Abstract

Copper and zinc toxicity to the freshwater alga Chlorella sp. was determined at a range of pH values (5.5-8.0) in a synthetic softwater (hardness 40-48 mg CaCO(3)/L). The effects of the metals on algal growth (cell division) rate were determined after 48-h exposure at pH 5.5, 6.0, 6.5, 7.0, 7.5, and 8.0. The toxicity of both metals was pH dependent. As pH decreased from 8.0 to 5.5, the copper concentration required to inhibit the algal growth rate by 50% (IC50) increased from 1.0 to 19 microg/L. For zinc, the IC50 increased from 52 to 2,700 microg/L over the same pH range. Changes in solution speciation alone did not explain the increased toxicity observed as the pH increased. Modelled Cu(2+) and Zn(2+) concentrations decreased with increasing pH, whereas toxicity was observed to increase. Measurements of extracellular (cell-bound) metal concentrations support the biotic ligand model (BLM) theory of competition between protons (H(+)) and metals for binding sites at the algal cell surface. Higher extracellular metal concentrations were observed at high pH, indicating reduced competition. Independent of pH, both extracellular and intracellular copper were directly related to growth inhibition in Chlorella sp., whereas zinc toxicity was related to cell-bound zinc only. These findings suggest that the algal cell surface may be considered as the biotic ligand in further development of a chronic BLM with microalgae. Conditional binding constants (log K) were determined experimentally (using measured intracellular metal concentrations) and theoretically (using concentration-response curves) for copper and zinc for Chlorella sp. at selected pH values. Excellent agreement was found indicating the possibility of using concentration-response data to estimate conditional metal-cell binding constants.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.