Abstract

The effect of Pb content in the rang of 0∼37wt.% on solidification behavior and shear performance of Sn3.0Ag0.5Cu/Cu joint was investigated. It was shown that Pb contamination showed a significant influence on the solidification behavior of Sn3.0Ag0.5Cu/Cu joint. A little amount of Pb resulted in the formation of ternary eutectic Sn-Pb-Ag phase with a low melting temperature and a mushy region between primary solidification phase and Sn-Pb-Ag phase during solidification stage of mixed joint. The mushy zone decreased with the increasing of Pb content and disappeared when Pb content in solder matrix of joint exceeded 18.34wt.% The addition of Pb in Sn3.0Ag0.5Cu/Cu joint has been shown to be beneficial to improve the shear force of SAC/Cu joint by using ball shear test method and the shear force of single interface mixed solder joint was in parabolic relationship with Pb content. The formation of ternary eutectic Sn-Pb-Ag phase and mushy zone in solidification stage had no obvious influence on the shear force of mixed solder joint.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.