Abstract

AbstractPolycrystalline ice at the melting point has been observed in the laboratory to contain veins of water at the places where three grains meet. Under uniaxial compression lenticular water inclusions appeared at grain boundaries perpendicular to the stress, while the nearby vein began to freeze. A similar effect occurred in tension on grain boundaries parallel to the stress. When the stress on the plane of the boundary was a pure shear stress, no effect was observed. The water lenses produced by stress increased in size and decreased in number after the stress was removed. The effect under compression is explained quantitatively by the combined effects of curvature and pressure on the melting point of an ice–water interface. The rate of formation of the lenses and of their coarsening is greatly reduced by the internal pressures set up in the lenses as a result of expansion on freezing and contraction on melting; transient creep to accommodate volume changes is an essential part of the process. The effect in a grain boundary under tension may arise from pressure caused by sliding on other grain boundaries; it was absent in a bicrystal.It is concluded that internal melting and freezing at grain boundaries and veins will occur in temperate glacier ice, with some effect, not discussed here, on its permeability to water. Any pure solid at its melting point which has a dihedral angle for the liquid phase in contact with a grain boundary between 0° and 60° should show similar behaviour, in that non-hydrostatic stress should cause liquid to move away from triple junctions between grains and into grain boundaries. There may be implications for the Frank theory of the upwelling of melt fluid in the Earth’s upper mantle.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.