Abstract
In this work, two types of Al-Mg-Si strips with different Mg/Si ratios were fabricated by vertical-type twin-roll casting (TRC), and the effect of the Mg/Si ratio on microstructure and tensile properties of the TRC strips was investigated. The TRC strips show the heterogeneous structure, composed of columnar dendrites near the surface of both sides and near-equiaxed grains in the central region. Serious central segregation of eutectic phases occurred in the TRC strips with Mg/Si = 0.5 (S0.5), while no obvious central segregation was found in the strips with Mg/Si = 2.9 (S2.9), which was ascribed to the different solidification path. The low Mg/Si ratio promoted precipitation during aging, which resulted in an increase of 85 MPa in yield strength compared to the S2.9 sample. However, intergranular fracture occurred in the S0.5 sample, lowering uniform elongation.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
