Abstract
Additive manufacturing (AM) can be used to fabricate heat pipes and two-phase heat sinks which have integrated wicking structures. These devices can be customized and have superior performance when compared with devices with conventionally fabricated wicks. The current work investigates the impact of build rate on the capillary performance of AM wicks fabricated by laser powder bed fusion (LPBF). The build rate was examined by varying the layer thickness from 30 µm to 80 µm for four different strut-based wick geometries: (i) body-centered cubic (BCC), (ii) face-centered cubic (FCC), (iii) simple cubic (SC), and (iv) fluorite. The mass rate-of-rise method was used to quantify the wick hydraulic parameters (namely wick permeability, K, and effective pore radius, reff). Layer thickness has a significant influence on wick permeability; layer thickness of 40 µm result in the highest value for all configurations but have a small effect on the effective pore radius. Layer thickness of 40 µm and 60 µm reached the highest K/reff ratio, primarily because of the permeability increase. We attribute this to poor build quality such as missing struts and less defined edges which facilitate low resistance to fluid flow. The SC 60 and BCC 40 configurations achieved the maximum capillary performance with K/reff of 1.34 µm and 1.42 µm, respectively. Overall, it was found that while increasing the build rate by varying layer thickness may affect the part build quality, it promotes hydraulic performance for some configurations by creating random rough surface morphologies and arteries, which help increase permeability.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have