Abstract
The article discusses the technology of laser processing of VT6 titanium alloy as a technological operation to improve properties and structure. A promising direction for reducing roughness during laser hardening with reflow can be the development of a process using additives that reduce the surface tension of the melt and increase the wettability of the surface. It was revealed that phase hardening and martensitic transformation β → α are the causes of hardening of titanium during laser processing. This is confirmed by a change in the width of the x-ray lines. It was found that during laser processing with a speed of 3.7 mm/s and higher, a fine-grained structure is achieved.The results show that, at a sufficiently high cooling rate of the substrate, the grain sizes remain practically unchanged. Russian Federation “The influence of magnetic fields and ion implantation on the electrical structure and properties of titanium, aluminum alloys and elementary semiconductors”
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
