Abstract
This paper examines the effect of heavy tamping (dynamic compaction) on highly porous structured residual clayey soil. The aim of this study is to analyse the feasibility of this technique when applied on lightly bonded residual soil sites, which are commonly found in tropical and subtropical regions. This soil has some interesting characteristics, such as high fine grain soil percentages (56% clay and 22% silt), a plastic index of 11%, high porosity (initial void ratio of 1.21), high hydraulic conductivity (about 10−5 m/s) and a high stiffness at small strains (E = 49.2-MPa). The research involves field [Cone Penetration Test (CPT) and the dynamic compaction] and laboratory (triaxial tests, characterization and hydraulic conductivity) investigation. According to laboratory tests, the void ratio decreased to 0.96, hydraulic conductivity decreased to 2.8 × 10−7 m/s, the effective peak friction angle (ϕ′) increased from 30.5° (in natural conditions) to about 35.5°, and the triaxial stiffness at small strains decreased to E = 20-MPa due to dynamic compaction. CPT results have shown an improved depth in which CPT tip strength (qt) increased from nearly 650-kPa to an average of 1700-kPa and CPT sleeve friction (fs) increased from approximately 50-kPa to about 130-kPa. Horizontal displacements were observed up to about 4.0 m of depth (approximately the same depth at which CPT results showed soil improvement). It was concluded that heavy tamping reduces soil voids and substantially increases soil strength, but also breaks soil structure and decreases soil stiffness. It is thus not a suitable ground improvement solution for highly porous structured residual clayey soil.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have