Abstract
The withdrawal capacity of screws in heat-treated spruce wood (Picea abies Karst.) was measured in the radial and tangential directions. Wood was heat-treated at temperatures of 150, 170, 190, 210, and 230 °C. Screw withdrawal capacity decreased as the degree of thermal modification was increased. Also, image analysis was used to measure the size of the deformed wood area around the screw, which increased with higher thermal modification temperatures. This leads to the practical recommendation that connections in heat-treated wood should be constructed with screws with larger diameters and deeper penetration. Moreover, larger spacing between screws is needed to ensure sufficient withdrawal capacity compared to non-treated wood.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.