Abstract
Equivalent hydraulic aperture and fracture surface roughness are two significant factors affecting the fluid flow behaviors in rock fractures. To understand the role of fracture surface roughness and aperture in the fluid flow through 3D self-affine rough fractures, roughness fracture surfaces with joint roughness coefficients equal to 2.5, 7.5, 12.5, and 17.5 were established, and the Navier–Stokes equation was used to compute the fluid flow in these 3D self-affine rough fractures with a mechanical aperture increase from 0.2 mm to 0.8 mm with a gradient of 0.2 mm. The results show that when the fracture mechanical aperture is 0.2 mm, the impact of fracture surface roughness on fluid flow is considerable, while this effect decreases obviously with the increase of fracture mechanical aperture. Comparing the permeability obtained by the Navier–Stokes equation with the cube law under different hydraulic gradients, we found that their deviation increased with the increase of hydraulic gradients. This allows for the definition of a critical hydraulic gradient ( J c ), below which the permeability can be properly predicted using the cubic law for its simplicity, and above which Forchheimer’s equation should be applied, and Forchheimer’s coefficients A , B , and J c can be calculated by the prediction equations established in this study.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.