Abstract
The aim of the current study is to investigate the effect of excessive penetration of welding and natural gas impurity particles on increasing erosion in elbows and reducers. To this end Euler–Lagrange model is used to simulate the two-phase solid–gas flow, the Discrete Phase Model (DPM), k-ε turbulent model and DNV erosion model are used to model the solid particles, natural gas flow and erosion rate, respectively. Erosion in elbows occurs downstream of vertical welding while in reducers is weaker and occurs at the inlet. The results show that erosion rate increases by increasing excessive penetration, particles size, particles flow rate and natural gas flow rate. The effect of excessive penetration becomes more important in high speed flows containing solid particles, in such a way that reducing excess penetration from h = 3 mm to h = 0 mm, causes 45% reduction in erosion rate in elbows containing 20 m/s natural gas flows. Therefore, for high velocity impure gas flows, it is recommended to reduce the allowable excessive penetration in welding standards.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.