The effect of ethylene glycol/citric acid molar ratio in the initial precursor of TiO2 nanoparticle paste synthesized by a polymerizable complex method on the photovoltaic properties of dye-sensitized solar cells

Abstract

A polymerizable complex method, also known as a Pechini method, was employed to synthesize titanium-sol (Ti-sol) as a matrix for TiO2 nanoparticle paste, suitable for fabrication of semiconducting mesoporous TiO2 layer as a photoanode of dye-sensitized solar cells (DSSCs). The purpose of the present work was to investigate the effect of ethylene glycol (EG)/citric acid (CA) molar ratio (Z), in the initial Ti-sol precursor, on the photovoltaic properties of DSSCs. From viscosity (µ) measurement and Fourier transform infrared (FTIR) spectrum of Ti-sols it was revealed that the amount of polyester in the sol decreases with increasing Z. The higher polyester content in the Ti-sols with lower Z ratios led to their higher surface tension (γ) and as a result the higher contact angle (α). The low wettability of fluorine doped tin oxide (FTO) coated glass with Ti-sol was the main reason of micro-cracking of TiO2 layers after sintering. This effect was significant for lower Z ratios. Micro-cracks increase the back electron–hole recombination rate. Also, at higher Z ratio, the back electron–hole recombination rate increased, which was due to the lower Ti4+ ions in the Ti-sol precursor and poor interconnection between TiO2 nanoparticles. Therefore, the maximum short circuit current density (Isc) and the maximum conversion efficiency (η) were obtained for Z=4. Fill factor (FF) decreased with increasing Z. But, open circuit voltage (Voc) was nearly independent of Z.