Abstract
This work explores experimentally the effects of DC electrical currents on lubricant film thickness alteration in lubricated sliding steel contacts in the boundary and mixed regime as measured by ultrasound. The experiments were performed in a two-electrode cell-based pin-on-disk tester instrumented with ultrasonic transducers. Unelectrified and electrified tribological tests were conducted on steel flat-on-flat contacts under various speeds and loads using both a mineral base oil and a gear oil. Film thickness, coefficient of friction (CoF), and electrical contact resistance (ECR) were measured during short experiments (30 s) in unelectrified and electrified (1.5 and 3 A) conditions. The results suggest that film thickness, CoF, and all ECR are altered by passing DC currents through the contact. In particular, film thickness increased and decreased, respectively, by applying electricity at the different speeds and loads tested. These alterations were majorly ascribed to oil viscosity decrease by local heat and surface oxidation caused by electrical discharge and break down at the interface.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
