Abstract
ABSTRACTPlasticizers are usually added to improve the mechanical and conditional (thermomechanical) quality of film coatings. Different molecular weights and concentrations of polyethylene glycol were incorporated as plasticizers in hydroxypropylmethylcellulose (HPMC) films. Thermomechanical and mechanical properties of cast films were tested using tensile and dynamic mechanical thermal analysis (DMTA) testing, respectively.The results, as expected, showed that addition of plasticizer caused a decrease in both mechanical and thermomechanical properties, but lower grades had more effect than higher molecular weights and concentrations.The conclusion could be drawn that combining different grades of plasticizers to optimize mechanical and thermomechanical properties is more efficient than using different concentrations of plasticizers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
