Abstract

BackgroundVariation in the composition of calcium silicate-based pulp capping materials could influence the discoloration potential of some of these materials, thus affecting the color and aesthetic appearance of the coronal tooth structure. Furthermore, contact with blood if hemostasis is not fully achieved may enhance this discoloration for some materials. Therefore the aim of this study was to evaluate in vitro the color change of coronal tooth structure after placing various calcium silicate-based materials in the pulp chamber in the presence or absence of blood.MehtodsMaxillary extracted premolars (n = 144) were sectioned and the crowns were separated from the roots. Pulp chambers were prepared to a standard size and then the tested materials (GMTA Angelus, ProRoot WMTA, Biodentine, TheraCal, and TotalFill) were placed with saline or with blood. Color change was assessed by spectrophotometry; prior to and after material placement at different time intervals of 24 h, 1 week, 1 month, 3 months, and 6 months. Color change (ΔE) values were calculated and statistically analyzed.ResultsIn the saline groups, Biodentine caused the least color change, while GMTA and WMTA caused the highest color change which were significantly different from the others (p < 0.001), TotalFill and TheraCal caused moderate changes. Adding blood increased the ΔE overall the tested materials to various degrees. Biodentine was the most affected by the blood, while MTA groups were the least affected, followed by TotalFill and then TheraCal. The increase in ΔE was significant over time up to 3 months, after which the increase was not significant.ConclusionsOverall, WMTA and GMTA caused the most severe discoloration. In saline, Biodentine caused the least discoloration, but it was the most affected by the presence of blood, although it still caused the least discoloration similar to that observed with TotatFill. TheraCal caused moderate discoloration but more than that caused by Biodentine and TotalFill.

Highlights

  • Variation in the composition of calcium silicate-based pulp capping materials could influence the discoloration potential of some of these materials, affecting the color and aesthetic appearance of the coronal tooth structure

  • In the saline groups, Biodentine caused the least color change, while Gray MTA (GMTA) and White MTA (WMTA) caused the highest color change which were significantly different from the others (p < 0.001), TotalFill and TheraCal caused moderate changes

  • While for the blood groups, the WMTA group was the most affected reaching a value of 5.16 which is even greater than the control (4.68) that had only a cotton pellet moistened with blood in the cavity of the pulp chamber

Read more

Summary

Introduction

Variation in the composition of calcium silicate-based pulp capping materials could influence the discoloration potential of some of these materials, affecting the color and aesthetic appearance of the coronal tooth structure. The aim of this study was to evaluate in vitro the color change of coronal tooth structure after placing various calcium silicate-based materials in the pulp chamber in the presence or absence of blood. MTA was considered to be the material of choice in cases of vital pulp therapy because of its favorable properties such as it’s biocompatibility with minimal cytotoxicity, bioinductivity with hard tissue formation barrier, Al‐Hiyasat et al BMC Oral Health (2021) 21:330 superior sealing ability, and few tunnel defects in dentinal bridge formation [1,2,3,4]. Blood contamination that may occur in vital pulp therapy procedures could be considered as an additional causative factor for discoloration [8,9,10]

Objectives
Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call