Abstract
This study investigated the performance of two acrylic rubbers on the improvement of mechanical and thermal properties of polylactic acid (PLA)/ poly(D-lactide) (PDLA) stereocomplex. The selected acrylic-based rubbers consisted of a commercial acrylic rubber (ACM) and acrylic core–shell rubber (CSR). In this work, 5 wt% PDLA was melt-blended with PLA to form PLA/PDLA stereocomplex (ST) in the presence of a 15 wt% acrylic-based rubber in an internal mixer at 180 °C and 50 rpm. It was found that the small amount of PDLA could successfully form stereocomplex crystals with PLA during melt mixing. The addition of acrylic-based rubbers not only increased the impact strength of the blends but also assisted PLA in forming more perfect crystals. This is because the rubbers could act as nucleation sites for PLA crystallization leading to smaller spherulite size than that of neat unmodified PLA. Comparatively, CSR could provide much higher %crystallinity with quicker nucleation onset than ACM in both PLA and ST systems, even though the crystallization rate was lower. In terms of mechanical properties, CSR also contributed to the highest impact strength due to the smaller size of CSR than ACM in both PLA and ST systems.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.